General; Side Panel; Control And Operating Board - RIKA INTEGRA II Instruction Manual

6. ASSEMBLY OF PANELS, OPTIONS

GENERAL

CAUTION! Only work on the unit when the mains plug
has been disconnected.
Your stove must be switched off and cooled before
any work is performed.
Do not allow objects (screws etc.) to fall into the fuel
container – they can block the screw conveyor and
damage the stove.

SIDE PANEL

1. Insert the side sections in the receiving seat
provided on the bottom section.
2. Push the side section against the stove until it is
vertical.
3. Then fasten with two screws in the pellet
container
Repeat on the other side of the stove.
CONTROL AND
BOARD
The INTEGRA II pellet stove has an internal
electronic control system located in the stove and
an operating board attached to the stove panels.
Work on the control system (mainboard) and the
operating board may only be performed by trained
specialist dealers or service technicians. Incorrect
handling of these parts leads to loss of warranty.
OPERATING
- 13 -