Shut Down Unit From Automatic Operation; Automatic Stop Controlled By Heating Time; Automatic Stop, Manual; Shut Down By Operating Mode In Standby - RIKA INTEGRA II Instruction Manual

On completion of the switch off program the display
goes off. When the "ON/OFF key is pressed a re-
start follows.
SWITCHING OFF
AUTOMATIC OPERATION
Heating time controlled automatic stop
If during automatic operation the "PE" output is
switched to OFF, then the stove will be switched off
at the end of a heating time as per the above-
described functions. The difference to manual
switch off is that TM is displayed instead of ON.
On completion of the switch off process the
following is displayed:
"TM" = Automatic operation (Time
mode) OFF switches off heating
operation.
A pre-programmed heating time re-sets the stove
automatically in operation andthe user can manually
change to the ON mode (e.g. if currently a heating
requirement outside the programmed heating times
is required).
Manual automatic stop
If during automatic operation the "ON/OFF" key is
pressed the stove goes immediately into switch off
operation. The same indication as described
previously is displayed. On completion of the exit
program the display switches off and the stove can
be re-switched to automatic mode by pressing the
"ON/OFF" key.
SWITCHING OFF BY CHANGING
OPERATINGMODE IN STANDBY
If you change to the Standby mode by pressing the
"ENTER" key in "Manual operation" and in automatic
operation, then switching off as described in the
STOVE
processabove will be carried out. On completion of
the switching off program the following display
appears:
To re-start the stove a corresponding mode must be
selected or the stove must be started with the
optional Tele-Control (telephone start).
PELLET
ROOM TEMPERATURE SENSOR
Using the external operating unit your pellet stove
functionality can
temperature control. This means that the room
temperature is measured by a sensor in the external
operating unit. The function is not part of the
standard delivery and can be retro-fitted if desired.
The corresponding extended functions of the stove
and the programming of the system values are
contained in the retro-fitting instructions.
TELE_CONTROL
CONTROL OPTIONAL)
The function is not part of the standard delivery and
can be retro-fitted if desired. The corresponding
extended
programming of the system values are contained in
the retro-fitting instructions.
- 20 -
"SB" = Standby
CONTROL (OPTIONAL)
be extended by
(TELEPHONE
functions of the stove
the room
and the