Table of Contents
Advertisement
Optional Equipment
4 2
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1
Remove the glass (see page 26). Remove the logs and coals (if installed - page 27)
2
Remove the burner (see illustration below).
Pull the burner forward, out
of the firebox.
NOTE:
After replacing the burner,
make sure this "O" ring
seals the burner tube to the
mixing tube.
Mixing Tube
Travis Industries
a
Remove the two cast floor pieces.
WARNING:
The burner is fragile -
handle it with care.
b
Reach into the firebox and
lift the burner upwards (lift
the burner from below).
Do not lift burner out by the
pins.
The tubes on the burner
insert into the tubes on the
mixing tube.
c
Burner Tube
(for qualified installers only)
9 3 5 0 8 1 1 8
Burner Replacement:
If the burner does not insert
easily, make sure the screws
holding the rear mixing tube
in place are slightly loose.
This allows the mixing tube
to move slightly and align
with the burner tube.
Make sure the burner
is fully seated. When
in place, the pilot
flame must align
directly above the
burner holes.
2 7 0 9 0 0
Advertisement
Table of Contents
