Bowflex Ultimate 2 Assembly Instructions Manual page 23

STEP 20
Parts:
• Squat Assembly (from step 19)
• Squat Back Pads
Tool:
• Hex Key (3/16")
20-1 Align holes in Squat Back Pads and
Squat Assembly.
20-2 Install and completely tighten hardware.
Hardware (1:1):
4 Button Head Screws (5/16" X 2 1/4")
STEP 21
Parts:
• Leg Extension Pivot Arm Assembly
• Roller Pads
• Webbing with Steel Ring
• Chrome Roller Tube
• End Caps
21-1 Insert Roller Pad Shaft through hole in
one of the rectangular arms. Place the
Webbing with Steel Rings between the
two rectangular arms, and continue to
slide the Shaft through the Webbing and
hole in opposite arm.
21-2 Slide Roller Pads and End Caps onto Roller
Pad Shaft.
Assembling Your Bowflex Ultimate
Button Head
Screw
4 Washers (5/16")
Roller Pad Shaft
Washer
Webbing with Steel Rings
End Cap
™
2
Squat Back
Leg Extension Pivot Arm
Assembly
Roller Pad
22
Pad