Bowflex Ultimate 2 Assembly Instructions Manual page 12

11
STEP 3 – Use two people for this step!
Parts:
• Front Base Platform
• Rear Base Platform
Tool:
• Hex Key (7/32")
• Wrench (9/16") - or Adjustable Wrench
3-1 Remove Wire Ties from Bushings.
3-2 Slide Front Base toward rear base until the
Locking Pins make contact with the side plates.
MAKE SURE the Flanges slide over the Bushings
during this procedure. (see Top Detail View)
3-3 Squeeze the Front Handle to retract the Locking
Pins and push Front Base completely into the
Rear Base. Release the handle and make sure
the Locking Pins protrude through the Side Plates.
3-4 Insert the Button Head Bolt and Washer then
squeeze Front Handle and fold Front Base up to
install Inside Washer and Hex nut. Completely
tighten hardware.
C
Button Head Screw
Washer
Hardware (1:1):
2 Button Head Screws (3/8" X 3")
Assembling Your Bowflex Ultimate
D
Remove Wire Ties
from Bushings
Bushings
Slide Front Base
towards Back Base
Until it Contacts Pins
Squeeze Handle and
Fold Front Base up
to install Hex Nut
and Washer
Washer
4 Washers (3/8") 2 Hex Nuts (3/8")
™
2
Locking Pin
TOP DETAIL VIEW
Make sure Flanges
slide over Bushings
Side Plate
TOP DETAIL VIEW
Hex Nut
A
B
Side Plate
Locking Pin