Bowflex Ultimate 2 Assembly Instructions Manual page 16

15
STEP 8
(Do Not Tighten The Hardware For This Step Until Step 9 )
Parts:
• Lower Lat Tower Uprights
• Squat Holder
• Cross Brace
Tool:
• Hex Key (7/32")
8-1 Insert Cross Brace and Squat Holder into Lower
Lat Tower Uprights. Make sure the Squat Holder
faces the the front of the Uprights. The label is on
the front and the screw holes are on the back of
the holder.
do not tighten
8-2 Install but
Step 9.
Hardware (1:1):
2 Button Head Screws (3/8" X 3/4")
STEP 9
Parts:
• Lower Lat Tower Assembly (from step 8)
• Base Assembly
Tools:
• Hex Key (7/32")
• Wrench (9/16") - or Adjustable Wrench
9-1 Place Lower Lat Tower over extrusions on
Base Assembly.
9-2 Install and completely tighten the hardware
from steps 8 and 9.
Hardware (1:1):
4 Button Head Screws (3/8" X 3/4")
Assembling Your Bowflex Ultimate
the hardware until
2 Washers (3/8")
2 Button Head Screws (3/8" X 2 1/2")
™
Button Head
Screw
Squat Holder
Label
The Cross Brace is on the
front of the Uprights
Lower Lat Tower
Assembly
Button Head
Screw 2 1/2"
Washer
8 Washers (3/8")
2
Cross Brace
Button Head
Screw 3/4"
Hex Nut
(Rod Pack Not Shown
For Clarity)
2 Nylock Nuts (3/8")