Cal Spas Pneumatic Series Owner's Manual page 293

Cal Spas Flow Diverter
CAL SPAS FLOW DIVERTER
The Cal Spas Flow Diverter system uses one or more motorized valve(s) to vary the jet action between certain
zones in the spa. These valve(s) are preset to stop at 7 different positions. Those positions are represented by
the LED lights on the Flow Diverter control panel.
As the valve(s) move, the LEDs will alternate between the current position and the desired position until the
desired position is reached.
Upon power-up, all the LEDs will illuminate one at a time as the valve(s) move for approximately 30 seconds.
Immediately following this start-up process, the valve(s) will move to the center psoition, at which time the
center LED will light.
Button Functions
Every press will move the valve(s) one stop. The LED that is lit will move up (clockwise) to the next
available position.
Every press will move the valve(s) one stop. The LED that is lit will move down (counter-clockwise)
to the next available position.
This button moves the valve(s) to the most extreme positions. The first press will move the valve(s)
and cause the LED to travel to the top (most clockwise) oistion. The next press wil move the valve(s)
in the other direction and the LED will move to the bottom (most counter-clockwise) position.
Pressing this button will center the valve(s) and the center LED will be lit.
Page 22
Figure 10. Cal Spas Flow Diverter
Owner's Manual
Owner's Manual