Cal Spas Pneumatic Series Owner's Manual page 227

9000 Electronic Operation
Optional Filter Cycle Programming
Mode
Press Time and then "
TIME icons. Use the Cursor to select the start time hour and repeat to select the minutes (each minute press
changes in increments of 5). Repeat once more to select the end time of the first filtration cycle. To set the
second filtration cycle, repeat the same steps. To exit filter cycle programming, press "
you wish select Continuous Filtration, set the filter 1 start and end times to the same exact time.
Mode/Programming
Mode
Press " Prog" to enter the programming mode and LCD will flash either STAND, ECON or SLEEP. Press
the Cursor to select the desired mode and then press "
Standard Mode - Maintains selected set temperature by activating the heater when it drops 1˚F below the set
temperature. Note that the last measured spa temperature displayed is accurate only when the pump has been ON
for at least 2 minutes.
Economy Mode - Heats the spa to set temperature only during filter cycles.
A) Is activated by pressing Jets #1 while in Economy Mode and operates the same as
|
Sleep Mode - Heats the spa to within 20˚F of set temperature and only during filter cycles.
Safety Suction System
The spas are equipped with a state-of-the-art "Safety Suction System"
in the event of a filtration or suction restriction. "SF" will display on the topside control panel. If this happens,
check all suction fittings, gate valves and filter cartridge for obstructions, then reset the system by pressing any
function button on the control pad.
Stand-By Mode
Press Cursor then Jets 1to turn
any button will reset the spa.
Jets1 and Jets2
The function of the Jets button varies according to the equipment set-up.
function as follows:
st low speed; 2 nd high speed; 3 rd off
One Pump - 1
One Pump w/Circulation Pump
st pump 1 low speed; 2 nd pump 1 high speed; 3 rd pump 2 high speed; 4 th off
Two Pumps - 1
Two Pumps w/ Circulation Pump
speed; 4 th pump 2 high speed; 5 th everything off
When spas don't have a circulation pump, pump 1 will run on low speed when the blower is "ON".
Owner's Manual
Prog" within 3 seconds and the display will show PROGRAM, FILTER 1, and START
standard mode for one hour time, a press of the "
Economy Mode immediately.
off all spa functions temporarily. This is helpful when changing a filter. Pressing
st circulation pump "ON"; 2 nd pump high speed; 3 rd off
- 1
st circulation pump "ON"; 2 nd pump 1 high speed; 3 rd pump 2 high
- 1
Mode
Prog" once to confirm selection.
This will automatically shut down the spa
Owner's Manual
Mode
Prog" at any time. If
Mode
Prog" button will revert to
The available configurations will
Page 19