Cal Spas Pneumatic Series Owner's Manual page 291

Owner's Manual 5000, 7000 and 9000 Electronic Operation
(optional Blower, Mister or a 3 rd Pump)
Option
7000 and 9000
Option - Press the Option button to turn on the Blower. Turn "OFF" after 15 minutes
Blower - Set B Dip Switch #3 to the "ON" position and plug cord into J6
Mister - Set B Dip Switch #11 to the "ON" position and move white wire from W12 to J48 1-speed operation:
"On/Off"
Automatic Chemical Dispenser
View Settings
To program press either Cursor, Jets1 and Light.
To display "ACD" on the panel if not already displayed, press Curser.
Press Jets1 to access the "ACD" settings. There are three chemical settings available and are indicated by the
first two digits:
"CL" - Chlorine
"SH"- Shock
"AT"- Aromatherapy
The third digit will indicate the remaining amount (if enabled), or 'N' if currently disabled:
"F"-Full
"E"- Empty
Press Cursor to move between settings.
Edit Settings
Press Jets1 to change the settings (the values will flash). Press Cursor to display available options. Three
options are available:
"r"- reset to full after filling chemical reservoir
"n"- disable the chemical from being dispensed
"y"- enable dispensing of that chemical
Press Jets1 while the value is flashing to accept the currently displayed setting. Press Light to exit and retain
the original setting.
Press Light to exit at any time. The menu will be exited automatically if there is 30 seconds of inactivity. If any
messages are displayed, press any button on the left side of the display (01, 02, 03 or 04) to remove message.
It will display again beginning at midnight. This will continue until the chemical level is reset to full or the
chemical is disabled.
Cabinet Light
Instant cabinet light adapter.
Invert (7000 and 9000)
Press the Invert button to invert the digits in the display upside down to view from within the spa. Another press
returns the display to its normal right side up position.
Clean-Up Cycle
When the pump or blower is turned off by a button press, or times out, a clean-up cycle will run for 30 minutes.
The pump and ozone generator will run for 1 hour.
Ozone
The Ozone Generator (if installed) will run during the filter cycle.
Page 20 Owner's Manual