Transmitting A Call; D Calling Back From The Queue Channel; D Using Call Memory - Icom IC-F3160 SERIES Operating Manual

2
BIIS 1200 OPERATION

■ Transmitting a call

A total of 3 ways for code selecton are avalable—selectng
the call code from memory, enterng the call code from the
keypad and callng back from the queue channel record.

D Using call memory

q Durng stand-by operaton, push [BIIS Button] to enter
the call code memory channel selecton mode.
• " " appears.
STATION1
CALL
w Push [CH Up] or [CH Down] to select the desred call
code.
e Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capablty s permt-
ted.
NOTE: When no answer back s receved, the trans-
cever repeats the call 3 tmes (default) automatcally,
and "WAIT" s dsplayed durng each call. However, an
error beep sounds and
no answer back s receved after the calls.
r Push [PTT] to transmt; release to receve.
t Push [Moni(Audi)] to send the 'Clear down' sgnal.
5
Appears
0001
BIIS TXC TXCE
s dsplayed when
"FAILED"

D Calling back from the queue channel

q Durng stand-by operaton, push and hold [BIIS Button]
for 1 sec. to enter the queue memory channel selecton
mode.
<
QUEUE
–QUEUE!–
CALL BIIS
w Push [CH Up] or [CH Down] to select the desred record.
e Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capablty s permt-
ted.
NOTE: When no answer back s receved, the trans-
cever repeats the call 3 tmes (default) automatcally,
and s dsplayed durng each call. However, an
"WAIT"
error beep sounds and
no answer back s receved after the calls.
r Push [PTT] to transmt; release to receve.
t Push [Moni(Audi)] to send the 'Clear down' sgnal.
>
TXC TXCE
s dsplayed when
"FAILED"