D Direct Code Entry - Icom IC-F3160 SERIES Operating Manual

D Direct code entry

q Durng stand-by operaton, push [TX Code Enter] to
enter the TX code edt mode.
• Code dgt for edtng blnks.
0500
CALL BIIS
w Push [TX Code Enter] to select the desred dgt to be ed-
ted.
• Dgt for edtng dffers accordng to the settng.
e Set the desred dgt usng [CH Up]/[CH Down] or 10-key-
pad*.
* 10-key versons only
r Push [TX Code Enter] to set the dgt, then the dgt to
the rght wll blnk automatcally.
• When the 10-keypad s used for settng, the dgt to the rght wll
blnk automatcally wthout pushng
t Repeat e and r to nput all allowable dgts.
TXC TXCE
[TX Code Enter]
.
BIIS 1200 OPERATION
y Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capablty s permt-
ted.
NOTE: When no answer back s receved, the trans-
cever repeats the call 3 tmes (default) automatcally,
and s dsplayed durng each call. However, an
" "
WAIT
error beep sounds and
no answer back s receved after the calls.
u Push [PTT] to transmt; release to receve.
i Push [Moni(Audi)] to send the 'Clear down' sgnal.
For your information
When the "UpDate" settng for the call code s enabled, the
set code s overwrtten nto the call code memory.
2
s dsplayed when
"FAILED"
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6