Snmp Host Table - D-Link DES-1228/ME User Manual

The following parameters can set:
Parameter
Community Name
View Name
Access Right
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the corresponding
under the Delete heading.

SNMP Host Table

Use the SNMP Host Table window to set up
SNMP trap recipients. To view this window, click
Administration > SNMP Manager > SNMP
Host Table. This will open the SNMP Host
Table window, as shown to the right. To delete
an existing SNMP Host Table entry, click the
corresponding under the Delete heading. To
display the current settings for an existing SNMP
Host Table entry, click the blue link for the entry
under the Host IP Address heading.
To add a new entry to the Switch's SNMP Host
Table, click the Add button in the upper left-hand
corner of the window. This will open the SNMP
Host Table Configuration window, as shown to
the right.
DES-1228/ME Layer 2 Fast Ethernet Managed Switch
Figure 6- 37. SNMP Community Table Configuration window
Description
Type an alphanumeric string of up to 32 characters that is used to identify members of an
SNMP community. This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch's SNMP agent.
Type an alphanumeric string of up to 32 characters that is used to identify the group of MIB
objects that a remote SNMP manager is allowed to access on the Switch. The view name
must exist in the SNMP View Table.
Read Only - Specifies that SNMP community members using the community string created
can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string created
can read from, and write to the contents of the MIBs on the Switch.
Figure 6- 38. SNMP Host Table window
Figure 6- 39. SNMP Host Table Configuration window
60