Ip Address - D-Link DES-1228/ME User Manual

ARP Aging Time (0-
65535)
GVRP
VLAN Trunk
Multicast VLAN
Asymmetric VLAN
Password Encryption
Click Apply to implement changes made.

IP Address

The IP address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the introduction of the DES-1228/ME CLI Manual or return to Section 4 of this manual for
more information. To change IP settings using the web manager click Administration > IP Address the following window will
be displayed.
To configure the Switch's IP address:
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Select Manual from the Get IP From drop-down menu.
2. Enter the appropriate IP Address and Subnet Mask.
3. If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of the Default
Gateway. If you will manage the Switch from the subnet on which it is installed, you can leave the default address
(0.0.0.0) in this field.
4. If no VLANs have been previously configured on the Switch, you can use the default VLAN Name. The default VLAN
contains all of the Switch ports as members. If VLANs have been previously configured on the Switch, you will need to
enter the VLAN Name of the VLAN that contains the port connected to the management station that will access the
Switch. The Switch will allow management access from stations in the same VLAN.
DES-1228/ME Layer 2 Fast Ethernet Managed Switch
Disabled.
The user may globally set the maximum amount of time, in minutes, an Address Resolution
Protocol (ARP) entry can remain in the Switch's ARP table, without being accessed, before it
is dropped from the table. The value may be set in the range of 0 to 65535 minutes with a
default setting of 20 minutes.
Use this pull-down menu to Enable or Disable GVRP on the Switch.
Use this pull-down menu to Enable or Disable VLAN Trunk on the Switch.
Use this pull-down menu to Enable or Disable Multicast VLAN on the Switch.
Use this pull-down menu to Enable or Disable Asymmetric VLAN on the Switch.
Use this pull-down menu to Enable or Disable Password Encryption on the Switch.
Password encryption allows the user to encrypt a password for additional security. Select
enable to change the password into encrypted form. When password encryption is disabled,
the user can specify that the password be in plain text form or in encrypted form. If the
password has been converted to encrypted form, the password will stay in encrypted form and
cannot be reverted back to plaintext form.
Figure 6- 2. IP Address Settings window
25