Table 2. Ut-4505/E/F/G/H/J/X Up Converter Specifications - Comtech EF Data UT-4505 Installation And Operation Manual

UT4500 Series Up Converter
Introduction

Table 2. UT-4505/E/F/G/H/J/X Up Converter Specifications

Characteristic
Frequency Range
UT-4505
UT-4505/E
UT-4505/F
UT-4505/G
UT-4505/H
UT-4505/J
Conversion
Step Size
Preset Channels
Stability Over Time
Stability Over Temp
IF Input
Noise Figure
Level
Range
Impedance
Return Loss
RF Output
Output Level
Intermodulation
Carrier Mute
Non–carrier Spurious
Carrier Spurious
AM to PM
Return Loss
Impedance
Transfer
Gain
Gain Adjust
Gain Stability
Ripple:
Slope
IF Bandwidth
Slope
Specification
5845 to 6425 MHz
6725 to 7025 MHz
6425 to 6725 MHz
5925 to 6725 MHz
5850 to 6650 MHz
7025 to 7075 MHz
Dual, No Inversion
125 kHz standard, 1kHz optional
32 Frequencies and Gains
± 1 x 10
± 1 x 10
12 dB Maximum at 0 dB Attenuation
-35 dBm Typical
52 to 88 or 104 to 176 MHz, (optional 50 to 80
50 or 75 Ω
23 dB Min. with IO Module or Switch Module
+17 dBm at 1 dB Compression
-50 dBc @ 0 dBm Output SCL
-70 dBc
-80 dBm
-65 dBc @ 0 dBm Output
0.1°/dB at -5 dBm Out
20 dB Minimum with IO Module
18 dB Minimum with Switch Module
50 Ω
35 dB ± 2 dB
0 to 25 in 0.25 dB Steps
0.1 dB Steps Optional
± 0.25 dB/Day
70 MHz IFCF
± 0.25 dB (± 18 MHz), optional ±20 MHz,
0.75 dB (± 36 MHz), optional ± 40 MHz,
140 MHz IFCF
0.05 dB/MHz
36 or 72 MHz, (optional 40 or 80 MHz, see Note)
0.05 dB/MHz
6
-9
/Day
-8
0 to 50°C
MHz or 100 to 180 MHz, see Note)
see Note)
see Note)
MN/UT4500.IOM
Revision 2