Config: Fltrec (Fault Recovery) Menu; Config: Conva Or Convb (Converter 'A' Or Converter 'B') Menus; Converter X: Mute/Freq - Comtech EF Data MBT-5000A Installation And Operation Manual

SNMP Trap IP Address: Version
Trap Version:
SNMPv1 SNMPv2
Use the ◄ ► arrow keys to select the trap version – SNMPv1 or SNMPv2 – and
then press ENTER.
5.2.2.2

CONFIG: FltRec (Fault Recovery) Menu

Fault Recovery: Manual
Automatic
Use the ◄ ► arrow keys to select Manual or Automatic, and then press ENTER.
5.2.2.3

CONFIG: ConvA or ConvB (Converter 'A' or Converter 'B') Menus

Converter X
Mute/Freq Attenuation
Where 'X' is the selected converter – Converter (Side) A or Converter (Side) B – use the
arrow keys to select Mute/Freq or Attenuation, and then press ENTER.
5.2.2.3.1

Converter X: Mute/Freq

For either side – A or B – the display differs depending on whether the selected module is a BUC
or BDC.
For example, if you select Converter A and it is a BUC:
CONFIG CnvA:
Tx=On
Use the ▼▲ arrow keys to select Tx as either On or Off (muted), and then press ENTER.
Similarly, if you select Converter B and it is a BDC:
CONFIG CnvB:
Rx=On Freq=01980.000MHz
Use the ▼▲ arrow keys to select Rx or Freq. Note that Freq displays only when the module is a
Ku-Band BDC unit.
Use the ▼▲ arrow keys to select Rx as either On or Off (muted), and then press ENTER.
To edit the frequency, use the ◄ ► arrow keys to first select the digit to edit, and then use the
▼▲ arrow keys to edit the value of that digit. Press ENTER when done.
Front Panel Operation
(◄ ► E)
(◄ ► E)
MBT-5000A L-Band Up/Down Converter System
5–12
Revision 1
MN-MBT-5000A