Front Panel Display; Front Panel Test Point Samples; Prime Power Switch; New In This Manual - Comtech EF Data UT-4505 Installation And Operation Manual

UT4500 Series Up Converter
Introduction
1.5 F P
RONT ANEL
The front panel display is a two line, 24-character, LCD display. Each configuration
function, or operating mode, is shown on the display when the operator enters a
command into the keypad on the front panel.
1.6 F P
RONT ANEL
Two test point connections are located on the front panel for monitoring the RF output
and the IF input. An SMA connector is provided for the RF output, and a BNC connector
is provided for the IF input. There also is an optional RF LO monitor available.
1.7 P P
RIME OWER
The on/off prime power switch is located on the rear of the chassis adjacent to the prime
power input connector. The power switch contains a filter and dual fuse. The dual fuse
is rated for 2 Amps.
1.8 N
EW IN THIS
Changes made to Initial Issue:
Incorporated Errata, A through D for Rev. 0
Added paragraph 1.8 for description of change.
D
ISPLAY
T P S
EST OINT
S
WITCH
M
ANUAL
AMPLES
16
MN/UT4500.IOM
Revision 2