Remote Notification - Powerware 9330 Installation & Operation Manual

•
Multi-Server Card --- connects up to three servers for monitoring and graceful
shutdown, supports load segment control, and has RS---232 signals for low
battery and AC failure.
•
ConnectUPS SNMP Card --- has Ethernet, modem, and SNMP capabilities.
•
Single-Port Card --- connects to the Powerware Expansion Chassis to enable
multiple communication options.
For installation and set up of an X-Slot card, please contact Powerware. See
"Getting Help" in the "Introduction" of this manual for contact information.
Refer to the manual supplied with the X-Slot card for user instructions.
ConnectUPS-X Web/SNMP Card
ConnectUPS SNMP Card
Relay Interface Card (AS-400)

13.5 Remote Notification

Remote Notification provides the user with the option of receiving alarms and
notices at a remote location. Remote Notification operates through a standard
computer modem. Using the Terminal mode, the user calls the UPS to perform
basic monitoring. In the event of a UPS alarm or notice, the user is notified at the
remote location. The UPS calls, through the modem, to the user's computer or
pager and leaves a message.
Remote Notification is an extension of the Terminal mode with the additional
support algorithms necessary to control an external modem. Connection to the
UPS is made when a user calls the UPS on the phone. The user has exactly the
same capabilities as if using a terminal connected directly to the UPS RS---232 port.
Remote Notification differs from the basic Terminal mode with the addition of Call
Answer, Call Out, and Housekeeping functions. The Call Answer function allows
the user to call into the UPS from a remote location and enter Terminal mode. The
Call Out function allows the UPS to be configured to call either a remote computer
or numeric paging service over the phone line. Call Out allows the UPS to call a
remote computer and leave a one-line descriptive message of the alarm or notice
condition. Numeric paging support allows the UPS to call a paging service and
send numeric messages. The Housekeeping function maintains the link between
the UPS and modem.
For connection and set up of a Modem, or to enable Remote Notify and Call Home
features within the UPS, please contact Powerware. See "Getting Help" in the
"Introduction" of this manual for contact information.
Powerware 9330 (10 kVA- -40 kVA) Installation and Operation
164201300 Rev. N 013004
Modbus Card
Figure 13 ---2. Optional X-Slot Cards
Multi-Server Card
Modem Card
Single-Port Card
13--3