T Indicator Is Lit Or Flashing Red - Epson EB-455Wi User Manual

Problem Solving
indicator is lit or flashing red
t
Status
Internal Error
Fan Error
Sensor Error
High Temp Error
(overheating)
Lamp Error
Lamp Failure
Auto Iris Error
Power Err. (Ballast)
Cause
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
The lamp turns off automatically and projection stops. Wait for approximately five minutes. After approximately five minutes
the projector switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are not blocked, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.s p.109,
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s
Contact List
When using the projector at an altitude of 1500 m or more, set High Altitude Mode to On. s
Check the following two points.
• Take out the lamp and check whether it is cracked. s
• Clean the air filter. s
If it is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local
dealer or the nearest address provided in the Support and Service Guide. s
If it is cracked: Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be careful
to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced). s
When using the projector at an altitude of 1500 m or more, set High Altitude Mode to On. s
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Remedy or Status
Epson Projector Contact List
Epson Projector Contact List
p.115
p.112
p.109
Epson Projector Contact List
: Lit : Flashing
Epson Projector
p.78
Epson Projector Contact List
Epson Projector Contact List
p.78
95
: Off