Epson EB-455Wi User Manual page 113

Replacing Consumables
Caution
Wait until the lamp has cooled down sufficiently before removing the lamp cover.
If the lamp is still hot, burns or other injuries may result. It takes approximately
one hour after the power has been turned off for the lamp to sufficiently cool
down.
Procedure
A
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cable.
B
Wait until the lamp has sufficiently cooled down, and then
remove the lamp cover at the top of the projector.
Loosen the lamp cover fixing screw with the screwdriver supplied
with the new lamp unit or a Phillips (+) screwdriver. Then slide the
lamp cover straight forward and lift to remove it.
C
Loosen the two lamp fixing screws.
D
Remove the old lamp by pulling the handle.
If the lamp is cracked, replace it with a new lamp or contact your
local dealer for further advice.
113
Epson Projector Contact List
s