Changing The Installation Mode - Epson EB-455Wi User Manual

Changing the Installation Mode

The projector supports the following three different projection methods.
Install according to the conditions of the installation location.
• Suspend the projector from the
ceiling and project images from
in front of the screen. (Front/
Ceiling projection)
• Setting up vertically and projec-
ting down (Front/Pointing Down
projection) (EB-465i/455Wi only)
At the time of shipment, the projector is set to be installed suspended from
a ceiling and to project images from the front of the screen
(Front/Ceiling).
Change the projection mode to suit the projection method.
• Suspend the projector from the
ceiling and project images from
behind a translucent screen.
(Rear/Ceiling projection)
• Set the projection mode from the Configuration menu. s
q
• Do not use any projection method other than Front/Ceiling, Rear/
Ceiling, or Front/Pointing Down projection.
Attention
•
For more information on setting up, contact the nearest address provided in
the Support and Service Guide or your local dealer. If it is not installed
correctly, it could cause an accident and injury.
•
When installing the projector, always use equipment that is suitable for the
installation method.
20
p.78