Easy Interactive Function (EB-465i/455Wi only)
H
A dot flashes in the top left of the screen.
If you touch the center of the dot with the tip of the Easy Interactive
Pen, the dot changes from flashing to lit.
Using Easy Interactive Pen
• Make sure you touch the center of the dot. The dot changes from
q
flashing to lit even if you touch an area outside of the circle. Since
calibration is performed using the position touched, positioning may
be offset if you touch an area other than the center of the circle.
• If you make a mistake during the operation, press the "Esc" key to
cancel calibration, and then try again.
p.18
s
I
The dots are displayed in order from the top left to bottom
right of the screen.
Repeat step 9 until all of the dots are lit.
It may take a few seconds for the Easy Interactive Driver icon to
q
change to connected status after all of the dots are lit.
J
After calibration, you can use the Easy Interactive Pen to
perform the same operations as a mouse on the projection
surface.
K
Use the following procedure to end the Easy Interactive
Function.
For Windows
Click the icon in the notification area of the taskbar, and select
Exit.
59