Reset To Default Values; Parallel Communications - Paxar 9800 Series Operator's Handbook Manual

R e s e t t o D e f a u l t V a l u e s
To change the setting, from the Main Menu select Setup, Port
Settings, then Serial Comm. Then, follow these steps:
1. Press until you see
2. Press Enter/Pause. You will see
3. Press or to make your selection, then press
Enter/Pause. Press Escape/Clear three times to exit to the
Main Menu.
The following defaults are restored: 9600 baud, No parity, 8
bit word length, and 1 stop bit.
P a r a l l e l C o m m u n i c a t i o n s
The parallel communications menu allows you to set the active
parallel port to either internal or external. The internal port is
used for printer options installed inside the printer, such as the
Ethernet communication port. Use the external selection when
connecting a printer cable or external device directly to the
parallel port.
The mode selection allows the user to select either compatible or
IEEE-1284 mode when using the selected parallel port. Usually,
the mode should be set to compatible for computer connection
using a parallel cable and to IEEE-1284 when using an Ethernet
port option. See Appendix B, "Accessories and Options" for more
information about Ethernet options.
SERIAL COMM
Reset
Are you sure?
No
Communication Values 5-5