Flow Control - Paxar 9800 Series Operator's Handbook Manual

2. Press Enter/Pause. You will see the current setting, for
example:
3. Press
Enter/Pause. Press Escape/Clear three times to exit to the
Main Menu.
F l o w C o n t r o l
To change the setting, from the Main Menu select Setup, Port
Settings, then Serial Comm. Then, follow these steps:
1. Press
2. Press Enter/Pause. You will see the current setting, for
example:
3. Press
press Enter/Pause. Press Escape/Clear three times to exit
to the Main Menu.
XON is 17; XOFF is 19. Set flow control to DTR for PC
computers (unless you have XON/XOFF software).
5-4 Communication Values
PARITY
None
or to display the parity you need, then press
or until you see
SERIAL COMM

Flow Control

FLOW CONTROL
DTR
or to display the flow control you need, then