Supply Type - Paxar 9800 Series Operator's Handbook Manual

2. Press Enter/Pause. You will see the current setting, for
example:
Enter knife adj
[-300/300]: +0
3. Press or to change the cut position. Pressing
decreases the value (moves the cut down);
(moves the cut up).
4. Press Enter/Pause when the number you need appears.
Press Escape/Clear to exit to the Setup menu.
S u p p l y Ty p e
You can print on aperture, black mark, die cut, or continuous
supplies. You have to tell the printer which supplies you are
using.
If you are using edge aperture supplies, use
the die cut setting. If you are using center
aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press or until you see
2. Press Enter/Pause to set the supply type option. You will see
the current setting, for example:
SUPPLY

Supply Type

SUPPLY TYPE
Black Mark
increases it
Setting Supply Options 4-9