Setting and Verifying the Network Connection
Setting and Verifying the Network Connection
After completing the hardware network connections to your
After Cable
system, you must complete the following tasks:
Connections
1. Set the network connection type.
2. Verify the network connection.
Two Network
There are two firmware network settings recognized by your
Settings
system–THICK for AUI Ethernet or 10BASE2 (ThinWire)
Ethernet, and TENBT for 10BASE-T Ethernet. The default
setting is THICK. See Table 5–5 for the network setting you
should use.
Table 5–5 Network Settings
For this network...
AUI Ethernet
10BASE2 (ThinWire)
Ethernet
10BASE-T Ethernet
5–12 Connecting Your System to a Network
Use this network
setting...
And this command
THICK
set ethernet thick
THICK
set ethernet thick
TENBT
set ethernet tenbt