Requirements For System Location; Hazards To Avoid - DEC 600s Owner's Manual

Location Choose a location for your system that meets the requirements
Requirements listed in Table 2–1:
Table 2–1 Requirements for System Location
Requirement Explanation
Dedicated power Power source must be 110–120 VAC or 220–240 VAC. Specific power
source with isolated requirements and electrical specifications are provided in Appendix A.
ground
Moderate Hardware operating conditions for the workstation or server range from
temperature 10°C to 35°C (50°F to 95°F).
Relative humidity Relative humidity should range between 10 percent and 90 percent.
Ample circulation Do not place your system near a heat source. Provide a minimum of 7.6
centimeters (3 inches) of clearance on all sides of the system unit. This
allows air to circulate around the system to prevent excess heat and to
keep the system air vents clean.
Working room Leave enough room on your desktop for your monitor, keyboard, mouse
pad, and any papers and materials that you may need.
What to Avoid When choosing a location for your workstation, try to avoid the
in a Location hazards listed in Table 2–2:
Table 2–2 Hazards to Avoid
Hazard How to Avoid
Dust and dirt Do not position the system unit directly on the floor. Dust and dirt
damage system components.
Heat and sunlight Do not place your system in direct sunlight, close to a heater, or near a
photocopier.
Unstable location Place your system on a desktop or table that is steady and strong enough
to support the system unit and the monitor. Your new workstation
weighs approximately 20.4 kilograms (45 pounds). A monitor can weigh
up to 34 kilograms (75 pounds).
Choosing a Location
Preparing to Install Your System 2–3