Connecting the Workstation
Connect the other end of the monitor video cable to the graphics
Step 3: Monitor
Video Cable to
connector on the system unit, as shown in Figure 3–2. The
graphics connector extends from one of the three TURBOchannel
System Unit
slots on the rear of the system unit. Preconfigured systems use
Slot 0. Tighten the thumbscrews on both sides of the connector
to ensure the cable is securely connected.
Figure 3–2 Connecting the Monitor Video Cable
3–8 Installing a Workstation System
0
1
I S
D N
S 3
2
MLO-008599