Configuring Ds0 Channels - Paradyne 3162 User Manual

Configuration

Configuring DS0 Channels

4-8
The DSU/CSU provides Cross Connect configuration options that allow you to do
the following:
H
Display the DS0 assignments for the network, DTE Drop/Insert (DSX-1), and
data port interfaces.
H
Allocate DS0 channels on the DTE Drop/Insert (DSX-1) interface to the
network interface.
H
Allocate DS0 channels on the network or DTE Drop/Insert (DSX-1) interface
to particular data ports.
H
Map data from one port to another.
H
Clear (deallocate) all DS0 channels from the network, DTE Drop/Insert
(DSX-1), or data port interface.
To allocate DS0 channels, begin by defining the logical channel configuration for
the network interface, and then the DTE Drop/Insert (DSX-1) interface, and then
any ports, if desired. See
channel configuration.
Blank configuration worksheets are provided at the back of Appendix C,
Configuration Options. These worksheets will help you prepare to perform the
procedures in this section.
only. See Appendix C for other useful worksheets.
NOTE:
The procedures in this section are examples only. Screen displays may vary
depending on the configuration of the DSU/CSU. For example, the DTE
Drop/Insert (DSX-1) interface is not displayed if this interface is disabled.
August 2000
Figure 4-4 for an example of a conceptual diagram of a
Figure 4-5 and Figure 4-6 are provided as an example
3162-A2-GB20-40