Paradyne 3162 User Manual page 116

Configuration Options
C-18
Table C-7. Communication Port Configuration Options (2 of 3)
Data Rate: 9.6
1.2 2.4 4.8 9.6 14.4
Configures the bit rate for the communication port.
1.2 – Sets the bit rate to 1200 bps (for asynchronous operation only).
2.4 – Sets the bit rate to 2400 bps.
4.8 – Sets the bit rate to 4800 bps.
9.6 – Sets the bit rate to 9600 bps.
14.4 – Sets the bit rate to 14,400 bps.
19.2 – Sets the bit rate to 19,200 bps.
38.4 – Sets the bit rate to 38,400 bps.
NOTE: This configuration option is not available if the communication port is
configured for synchronous operation and the clock source is external.
Character Length: 8
7 8
Configures the character length (7 or 8 bits) for the communication port.
NOTES: – This configuration option must be set to 8 if the communication port is
used as the network communication link.
– This configuration option is not available if the communication port is
configured for synchronous operation.
Parity: None
None Even Odd
Configures the parity (none, even, or odd) for the communication port.
NOTE: This configuration option is not available if the communication port is
configured for synchronous operation.
Stop Bits: 1
1 1.5 2
Configures the number of stop bits (1, 1.5, or 2) for the communication port.
NOTE: This configuration option is not available if the communication port is
configured for synchronous operation.
Ignore Control Leads:
Disable DTR
Specifies whether the DSU/CSU ignores the state of the Data Terminal Ready (DTR)
input to the communication port.
Disable – The control leads are treated in the standard manner.
DTR – DTR is ignored.
NOTE: This configuration option is not available if the communication port is
configured for synchronous operation.
Password Required: Disable
Enable Disable
Activates a password prompt that prevents access until a password is entered.
Enable – Prompts the communications port user to enter a password.
Disable – Does not require a password.
August 2000
19.2 38.4
Disable
3162-A2-GB20-40