Table of Contents
Advertisement
Configuration Using the Web Interface
Overview
This chapter provides instructions on how to configure the ATM line cards using
the SCP card's web interface.
Configuring Spectrum Management
Use the Configuration - DSL General screen to enable and disable Spectrum
Management. When Spectrum Management is enabled, the maximum transmit
speeds and maximum transmit power are limited to meet local spectrum
management guidelines.
Procedure
To enable or disable Spectrum Management:
8900-A2-GB20-50
If you would like to configure the
card using . . .
The BLC's TL1 Interface (when an SCP
card with an ATM uplink is used)
The BLC's router-like command line
interface (when an SCP card with an IP
uplink is used)
GrandVIEW EMS
SNMP using another EMS
1. Select Disable or Enable from the drop-down list.
2. For the 8985 line card, additionally select the Spectrum Management Region:
— ANSI T1417 – To select American National Standards Institute T1.417
definitions
— ANFP ND 1602 – To select Access Network Frequency Plan ND1602
definitions
3. Click on Apply.
August 2005
See the . . .
8620 and 8820 Broadband Loop Carrier TL1
Interface Reference
8620 and 8820 Broadband Loop Carrier
Command Line Interface Reference
GrandVIEW EMS User's Guide
8620 and 8820 Broadband Loop Carrier SNMP
Reference
3
3-1
Advertisement
Table of Contents
