Table of Contents
Advertisement
Using the Special Context menu
The
the source computer during a mouse and keyboard control session. (You can display this
menu only during a control session.)
Figure 32.
To use the
1.
2.
To close the
Multicast Error Logging
Using either the QGE 100 Viewer or Administrator, you can set up the QGE to log
error conditions that occur while the encoder is operating in multicast mode. When
logging is enabled, the number of recent errors (since last check) and total errors (since
logging began) are recorded in the Multicast Errors column of the QGE 100 List on the
Administrator main window. This log can be used for trouble-shooting.
To set up error logging via either software program:
1.
2.
3.
4.
Special Context
pop-up menu contains commands that you can select to send to
Special Context Pop-up Menu
Special Context
menu:
Press the key combination specified on the Mouse & Keyboard Options window (by
default, this is <Ctrl> + <F2>). The
pointer appears on the Viewer window.
Move the mouse pointer to the desired menu option and click the command to
issue it to the source computer, or click
session.
Special Context
From the
menu, select
Tools
Figure 33.
Logging Options Window
Select the
Enable Multicast Error Logging
In the
field, enter the number of seconds (
Logging Interval
elapse between log entries. (The default is
Click
.
OK
menu pops up and a mouse
Special Context
End Keyboard And Mouse
menu, press <Esc> on your viewing computer keyboard.
. The Logging Options window opens.
Logging
check box.
9
.)
QGE 100 • Software Configuration and Control
to end the control
through
) that will
1
9
44
Advertisement
Table of Contents
