Table of Contents
Advertisement
Viewing the QGE 100 Data Stream
Streamed QGE 100 data can be decoded and displayed using any of the following viewing
platforms:
•
A Quantum Elite Videowall Processor (multicast mode only)
•
A computer running QGE 100 Viewer software
•
A computer running QGE 100 Administrator software
Managing the Network
Use the QGE 100 Administrator software to configure the image stream and IP address
settings of QGE 100 units.
Image streams
The following user-definable settings are available on the QGE 100 unit to facilitate the
management of the image streams:
•
Frame rate
•
Bandwidth limit
•
TTL (Time to Live)
•
Refresh rate
•
Multicast address
•
IP Settings
Network settings
You can also configure the following IP settings for each unit:
Available settings are:
•
IP address
•
Subnet mask
•
Default gateway
•
DNS Server
•
WINS Server
•
Network name
•
Network port speed
•
DHCP enable
Operating System
Although it has keyboard, mouse, and monitor connections, the QGE 100 is not a PC. It
does not have a Windows graphical user interface, and you cannot connect a monitor,
keyboard, and mouse directly to it to access any setup features or to control the operating
system.
Image retention
After the QGE 100 has been powered off, all memory and frame stores are purged.
Therefore, the QGE itself does not retain any representation of the sources that were
displayed on the system prior to shutdown.
QGE 100 • Introduction
4
Advertisement
Table of Contents
