Connecting The Qge 100 To The Network; Connection Procedure - Extron electronics QGE 100 User Manual

Connecting the QGE 100 to the Network

Source content that is captured by the QGE 100 from a source computer is transmitted to
a viewing device via TCP/IP over an Ethernet network.

Connection Procedure

Connect the QGE to your network as follows:
1.
2.
Plug the DVI-A connector of the adapter into the QGE DVI-I Out port.
Analog Monitor
Figure 8.
Connecting the Monitor of an Analog Source Computer to the
Analog to DVI Adapter
NOTE: If you use a monitor cable or adapter other than the one provided with
the QGE 100, ensure that all pins are properly interconnected; otherwise,
the computer graphics card or monitor may not operate correctly.
Connect a standard straight-through Ethernet patch cable (not supplied) between the
LAN port on the QGE 100 rear panel to a switch or router that is connected to the
same network as your viewing device. (A shielded twisted pair cable is recommended
for this connection.) The network port on the router or switch must be capable of
supporting a 100BASE-T connection.
Pins:
12345678
Pin Wire Color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
Insert Twisted
8 Brown
Pair Wires
T568B
RJ-45
A cable that is wired the same at both ends is called a "straight-through"
Connector
cable, because no pin or pair assignments are swapped.
Figure 9. RJ-45 Connector Wiring
Straight-through Cable
End 1 End 2
Wire Color
White-orange
TD+ (+ data transmit)
Orange TD- (- data transmit)
RD+ (+ data receive)
White-green
NC
Blue
NC
White-blue
Green RD- (- data receive)
NC
White-brown
Brown NC
T568B
QGE 100 • Installation and Maintenance
Analog to DVI
Adapter
To QGE 100
DVI I Out Port
Function
12