Table of Contents
Advertisement
Installation and
Operation
This section provides the steps to install the QGE 100. It also describes the front and rear
panel components and provides instructions for cabling and operating the encoder. The
following topics are included:
•
•
•
•
•
•
•
Installation Overview
To install and set up the QGE 100 encoder, follow the steps listed below. Where
appropriate, each step contains a reference to detailed explanations later in this section;
refer to these sections as needed.
WARNING:
CAUTION: Keep the QGE 100 in a horizontal position while it is operating. When
1.
2.
3.
4.
5.
6.
Installation Overview
Rear Panel Features
Connecting the Source Computer to the QGE 100
Connecting the QGE 100 to the Network
Connecting Power to the Unit
Connection Diagrams
Front Panel Features
To avoid the risk of electric shock or product damage due to
condensation, always allow the QGE 100 and the provided power supply
to become acclimated to ambient temperature and humidity for at least
30 minutes before switching it on. This is particularly important when you
are moving the unit from a cold to a warm location.
using it free-standing (not rack mounted), place it on a stable, flat, and
level surface. Ensure that the surface finish will not be affected by the heat
produced by the QGE when the unit is in use.
Disconnect power from the QGE and power off all other equipment in the system.
Connect the mouse PC, keyboard PC, and DVI-I In ports of the QGE, respectively, to
the PS/2 mouse and keyboard ports and the monitor port of the source computer (see
"Connecting the Source Computer to the QGE
Connect the mouse, keyboard, and monitor of the source computer, respectively, to
the Periph mouse and keyboard ports and the DVI-I Out port of the QGE.
Connect the QGE Ethernet port to the network port of your host (viewing) computer
or a Quantum Elite videowall (see
page 12).
Power on the QGE 100 (see
Power on the source computer. Always do this step last.
100" on page 10).
"Connecting the QGE 100 to the
"Connecting Power to the
QGE 100 • Installation and Operation
Network" on
Unit" on page 13).
8
Advertisement
Table of Contents
