Error Messages; Command/Response Table For Sis Commands - Extron electronics RGB-DVI 300 User Manual

Error Messages

If the RGB-DVI 300, RGB-HDMI 300, or RGB-HDMI 300 A does not support or recognize the
entered commands, one of the following responses may be issued.
E10 = Invalid command
E11 = Invalid preset number
E13 = Invalid parameter

Command/Response Table for SIS Commands

Command
Input Video Format
Set Format
View Detected Format
Auto-Image
Enable
Disable
Execute
View Auto-Image status
VGA Input EDID Emulation
Specify a value
View
Horizontal Start
Set a horizontal start
value
Increment horizontal start
value
Decrement horizontal
start value
View horizontal start
value
ASCII Command Response
(host to unit) (unit to host)
X!
1* \ Typ1*
X!]
1*\ Typ*
1*1A
Img1*1
1*0A
Img1*0
]
A
Img
1A Img1*
EX1% X1^ } X1%
* EDID Edid
E } X1%
EDID Edid
EX# } X#]
HSRT Hsrt
E } X#]
+HSRT Hsrt
E } X#]
-HSRT Hsrt
E } X#]
HSRT Hsrt
RGB-DVI 300 and RGB-HDMI 300 (A) • SIS Commands
E14 = Not valid for this config.
E17 = Invalid command for signal type
E22 = Busy
Additional Description
X!]
Sets input format
0 = No signal (for query only)
1 = RGB (default)
2 = YUV
3 = AUTO
View current video input format.
]
Auto-Image input when selected.
]
Disable Auto-Image.
Execute Auto-Image on current input.
X@]
View current Auto-Image setting
0 = Off (Disabled)
1 = On (Enabled)
X1^]
* Sets EDID resolution
X1^
(see tables on page 33).
(Default 32*0 sets EDID to match the
current output resolution).
NOTE: An incompatible combination
of resolution and refresh rate
results in an error message.
See Table 1 on page 9.
X1^]
* View EDID resolution and refresh rate.
Set the horizontal location of the first
active pixel
input.
Increases the horizontal start value by 1.
Decreases the horizontal start value by 1.
View the horizontal location of the first
active pixel.
X!
.
X@
.
X1%
and refresh rate
X#
(from 0 to 255) for active
35