Password Information; Error Responses; Commands And Responses; Using The Command And Response Tables - Extron electronics DVS 605 Series User Manual

Password Information

The
by a carriage return. The prompt is repeated if the correct password is not entered.
NOTE: The factory configured passwords for all accounts on this device have been set
If the correct password is entered, the unit responds with ] Login Administrator ]
or ] Login User ], depending on password entered. If passwords are the same for both
administrator and user, the unit defaults to administrator privileges.

Error Responses

When the DVS 605 receives a valid command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command because the
command contains invalid parameters, it returns an error response to the host.
Error numbers
E01 — Invalid input number
E06 — Invalid switch attempt in this mode
E10 — Invalid command
E11 — Invalid preset number
E12 — Invalid port number
E13 — Invalid parameter
E14 — Not valid for this configuration
Error response references
14
24
28

Commands and Responses

Using the Command and Response Tables

The
DVS 605 recognizes as valid. The tables show the responses that are returned to the host
with a description of the command function or command execution results. Also included
are examples of commands in ASCII (Telnet) and URL encoded (web).
NOTE: Upper and lower case text can be used interchangeably.
Space
Figure 26.
Password: prompt requires a password (administrator level or user level) followed
]
to the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is no password (see
change the password).
= Commands that give an E14 (invalid command for this configuration) error if sent
to a product whose current configuration does not support the command
= Commands giving an E24 (privilege violation) error if not logged in at administrator level
= Commands that may give an E28 (file not found) error
SIS Command and Response Table
ASCII to HEX Conversion Table
ASCII to Hexadecimal Character Conversion Table
Password Page
E17 — Invalid command for signal type
E22 — Busy
E24 — Privilege violation
E25 — Device not present
E26 — Maximum number of
connections exceeded
E28 — Bad filename/file not found
starting on page 42 for SIS commands the
•
DVS 605 • SIS Communication and Control
on page 121 to
35