Adjusting The Blower Speed; Normal Operating Sounds; Normal Operating Odors - Travis Industries DVL EF Insert Owner's Manual

Adjusting the Blower Speed

The internal blower helps transfer
the heat from the heater into the
room. It will not turn on until the
heater is up to temperature
(approximately 10 minutes after
starting). See the illustration below
for instructions on adjusting the
blower speed.

Normal Operating Sounds

Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve is turned on
and off you will hear a dull clicking
sound. This is the valve opening up
and shutting down.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas
may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if
the appliance was left idle for a long period.
Travis Industries
Operation
OFF
HI
LO
BLOWER
CONTROL
4 0 4 1 0 2 8
Blower Knob
Turn the knob all the way counter-clockwise to turn
the blower off. One click clockwise turns the
blower to high speed. Turning the knob clockwise
from the high position decreases the speed of the
blower.
Blower
This heater uses a blower to push heated air
into the room. You will hear the sound of air
movement that increases as the speed is
increased.
The appliance will creak
with change of temperature.
Extinction Pops
It is not unusual, especially on
Propane (LP) appliances, to
experience a "pop" when the
burner is shut off.
Blower Snap Disk
This part can produce a clicking
sound as it turns the blower on
and off.
2 5
1 0 0 - 0 1 1 5 1