Travis Industries DVL EF Insert Owner's Manual page 13

Installation
Installation Without Surround Panels
Travis Industries
(for qualified installers only)
Use a knife to cut out the on/off switch hole
a
(the label covers a square hole in the bracket).
Disconnect the on/off switch from
b
the red and brown wires. Insert
the switch into the hole until it
locks in place. Re-attach the red
and brown wires (orientation does
not matter).
4 0 4 1 0 2 8
Keep the jumper wire in
place while installing.
1 3
c
1 0 0 - 0 1 1 5 1