Table of Contents
Advertisement
Installation
Installation Warnings:
!
Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
!
This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
!
This appliance must be installed in accordance with all local codes, if any; if not,
follow ANSI Z223.1 and NFPA 54(88) in the USA and B-149 in Canada.
!
In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4
and Gas-Equipped Recreational Vehicles and Mobile Housing.
be installed in Manufactured Housing only after the home is site located.
!
The DVL Insert is designed to operate on natural gas (NG) or propane (LP).
!
All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
!
Notify your insurance company before hooking up this heater.
!
The requirements listed below are divided into sections.
met simultaneously.
should follow the procedure best suited for the installation.
Additional Items Required for Installation
•
6-5/8" to 3" & 4" Co-Linear Adapter – W/ Flashing (Travis Part # 98900124)
•
Face
•
Gas Hookup Equipment
•
Surround Panels (Optional - see "Installation without Surround Panels")
•
3" and 4" Diameter Gas Liner
•
Direct Vent Cap (Simpson Duravent Part # 991)
Packing List
• DVL Insert
• Log Set (Log Set, Coals, and Embers)
• Owner's Manual
• Two Leveling Bolts
• Propane Conversion Kit
• "Fireplace Altered" tag (attach to the fireplace)
Items Packed with the Face
• Face (with attachment hardware)
Order of Installation
1
If the heater is to use propane, install the propane conversion kit (see page 32)
2
Install gas line into the fireplace (do not connect to unit)
3
Position the heater (see "Insert Placement")
4
Connect the gas line and gas vent to the appliance.
5
Install the optional surround panels and trim. Attach the on/off switch.
6
Follow the instructions under "Finalizing the Installation" on pages 17 through 21.
Travis Industries
(for qualified installers only)
The order of installation
• Face Installation Instructions
4 0 4 1 0 2 8
All requirements must be
is not rigid – the qualified installer
• 8" Pipe Inlet (3/8" dia.)
• Door Latch Key
• Block Off Plate
• (2) Fireback Clips (for ceramic firebacks only)
This appliance may
1 0 0 - 0 1 1 5 1
7
Advertisement
Table of Contents
