Table of Contents
Advertisement
Pre-Installation Checklist for Static Addressing
Before performing static addressing, verify that all the requirements listed in the
Network Requirements
consider item
4.
values for the following parameters. Failure to do so can cause data entry errors that prevent
the telephone from working. Such errors can also have a negative impact on your network. Print
copies of this checklist for each subnet.
1.
The IP address of the media server.
2.
The transport layer port number of the address of the Management Complex
(media server/gatekeeper). Although this can be a value between 0 and 65535,
the default value is 1719. Do not change this value unless it conflicts with an
existing port assignment.
3.
The IP address of the gateway/router.
4.
The IP netmask.
5.
The IP address of the HTTP server.
Static Addressing Installation
The usual way to assign IP addresses to IP telephones is the automatic method described in
Dynamic Addressing Process
assignment of IP addresses is desired.
!
CAUTION:
Static addressing is necessary when a DHCP server is unavailable.
CAUTION:
Because of the increased opportunities for text entry errors associated with static
addressing, we very strongly recommend that a DHCP server be installed and
static addressing avoided.
section of the
Pre-Installation Checklist
on page 11, as it refers to the DHCP server. In addition, you must have the
on page 20. There might be times, however, when manual
Pre-Installation Checklist for Static Addressing
are met. You do not have to
Verify These
Issue 1 June 2007
29
Advertisement
Table of Contents
