Table of Contents
Advertisement
Local Programming Option
Set 802.1X operational mode
Static addressing
Automatic Gain Control
DHCP chaddr field value
Clear values to factory defaults
Enable/disable Debug Mode
Group Identifier
Interface Control
Event Logging
Reset the telephone
Restart the telephone
Signaling protocol identifier
(not applicable to Release 1.0)
Site-Specific Option number
Test the telephone
View current parameter values
and file names
Note:
Unless otherwise prohibited using administration, the user can view but not
Note:
change most of the parameters associated with Local Administrative Procedures.
For more information about this option, see the applicable user guide(s).
Code
8 0 2 1 X (8 0 2 1 9)
A D D R (2 3 3 7)
A G C (2 4 2)
C H A D D R (2 4 2 3 3 7)
C L E A R (2 5 3 2 7)
D E B U G (3 3 2 8 4)
G R O U P (4 7 6 8 7)
I N T (4 6 8)
L O G (5 6 4)
R E S E T (7 3 7 3 8)
R E S E T (7 3 7 3 8)
S I G (7 4 4)
S S O N (7 7 6 6)
T E S T (8 3 7 8)
V I E W (8 4 3 9)
About Local Administrative Procedures
See
Set the 802.1X Operational
Mode
on page 28.
Static Addressing Installation on
page
29.
Disable/Enable Automatic Gain
Control
on page 32.
Manually Setting the DHCP
Client Hardware Address on
page
34.
Clear Procedure on page
Disable/Enable Debug Mode
page 36.
Group Identifier on page
Interface Control on page
Disable/Enable Event
Logging
on page 40.
Reset System Values on
page
42.
Restart the Telephone on
page
43.
Signaling Protocol Identifier on
page
44.
Site-Specific Option Number
Setting
on page 45.
Self-Test Procedure on page
The View Administrative
Option
on page 54.
Issue 1 June 2007
35.
on
37.
38.
46.
27
Advertisement
Table of Contents
