Pre-Installation Checklist For Static Addressing - Avaya 4600 Series Installation Manual

4600 Series IP Telephone Installation Guide
2. Attempts to enter invalid data are rejected, and the phone emits an error beep.
3. If a numeric digit is entered for a value or for a field of an IP address or subnet mask after only
a zero has been entered, the new digit will replace the zero.
4. Press the # button to go to the next step.
5. To backspace within a field, see the chart below, depending on the type of phone being
installed:
IP Telephone #
4602
4606
4612
4624
4620
4630
When you press the applicable button or key, the most recently entered digit or period is
erased from the display, and the cursor is left in the erased character's former position.
Pre-Installation Checklist for Static
Addressing
Before performing static addressing on the 4600 Series IP Telephone, verify that all of the
requirements listed in the Requirements to Verify about the Network section of the Pre-Installation
Checklist in Chapter 2 have been met (other than item 4 referring to the DHCP server). In addition,
you must have the values for the following parameters. Failure to do so may cause errors during
data entry, which will prevent the telephone from working and may have a negative impact on your
network. Print copies of this checklist for each subnet.
1. The IP Address of the call server/gatekeeper
2. The transport layer port number of the Address of the Management Complex (call
server/gatekeeper). Although this may be a value between 0 and 65535, the default
value is 1719 and should not be changed unless this conflicts with an existing port
assignment.
3. The IP Address of the gateway/router

Pre-Installation Checklist for Static Addressing

3-2
Backspace Alternative
Speaker button
Conference button
Left-most softkey or
Previous button
Left-most softkey or
Previous button
Left-most softkey
Headset button
3