Figure 2-10. Removing The Display - HP OmniBook 6000 Service Manual

Screws, M2.5×6mm (4)
Label with DIP switch
settings
Screws, M2.5×6mm (2)
Reassembly Notes
Before installing any screws, make sure the center hinge cover fits over the tab in the bottom case.
Important
Make sure the DIP switches on the display interface PCA match the settings shown on the
label on the display cable, or you risk damaging the display.
If you change the DIP switches, you must also reprogram the EEPROM for the new display—
see page 2-26. If the EEPROM is not programmed correctly, the display will not turn on.
2-14 Removal and Replacement

Figure 2-10. Removing the Display

Screws,
M2.5×6mm (5)
HP OmniBook 6000