HP OmniBook 6000 Service Manual page 50

Component
Doors, PCMCIA
Heatsink (with fan)
Keyboard
Panel, sound/IR
Panel, mini-PCI
Panel, vent
PCA, display interface
2-30 Removal and Replacement
Removal Procedure
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
See page 2-17.
See page 2-15.
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Additional Steps
See the figure on page 2-24.
Reassembly Notes: Make sure the volume control is
oriented properly (pins facing inward). Insert the tabs
on the ends of the panel into the slots in the bottom
case.
On the rear of the computer, remove the screw at the
far left end (nearest the mini-PCI panel).
Reassembly Notes: Insert the pin on the back end of
the panel under the bracket on the bottom case, and
the tabs on the ends of the cover into the slots in the
bottom case.
Remove the screw from the board (see the figure on
page 2-25), and carefully lift the board off of the
connector underneath.
Reassembly Notes: Make sure the DIP switches on
the new display interface PCA match the settings
shown on the label on the display cable, or you risk
damaging the display.
HP OmniBook 6000