HP OmniBook 6000 Service Manual page 65

Symptom Call Center:
Suggestions
Computer is still on Press CTRL+ALT+DEL and
but stops end any application that is
responding. not responding.
Slide and hold the power
button four seconds to turn
off and reset the computer.
Press the blue sleep button
to turn the computer back on.
If the above fails, insert a
straightened paper clip into
the system-off switch. Then
press the blue sleep button
to turn the computer back on.
Accessories
Docking product I/O Make sure ac power is
problems connected to the dock.
Make sure computer is fully
inserted in dock.
Check computer's power
supply.
Check settings in BIOS
Setup.
Try using the corresponding
port on the computer while
undocked.
General plug-in Check module contacts.
module problems
Push system-off button.
HP OmniBook 6000
Repair Center: Repair Center:
Likely Causes Comments
Docking product. Test the corresponding
OmniBook ports while
Motherboard.
undocked.
The port replicator and mini
dock are not repairable—they
must be exchanged.
The docking system is
repairable—see its service
manual.
Plug-in module or Plug-in modules cannot be
contacts. repaired, and must be
exchanged.
Motherboard.
Troubleshooting and Diagnostics 3-13