Rear Panel Layout; Primary Dhd Controller Rear Panel - Runco 3Dimension D-73d Ultra Installation & Operation Manual

Figure 2-5 shows the rear connector panel on the Primary DHD Controller.
1
DHD4
Primary
7
Figure 2-5. Primary DHD Controller Rear Panel
1. MAIN POWER SWITCH
Disconnects or applies power to the DHD Controller.
2. TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
3. USB
A standard, USB Series "B" connection to a personal computer, for performing
software upgrades and other service procedures.
4. RS-232 (To Accessory Box)
A male, 9-pin D-sub connector for interfacing with the Secondary DHD Controller.
(Use a "null-modem" serial cable for this connection.)
5. Display Control
Connect this to the RS-232 input on the left-eye (top) optical engine on the D-73d
projector.
6. IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
7. POWER INPUT (100 to 240 VAC)
Connect the DHD Controller to power here.
8. HD2 Input (5 x Analog BNCs)
Connect the HD 2 input to the Left Analog output on the 3Dimension Processor.
The HD 1 input is not used with the D-73d. Connect your Component/RGBHV
sources to the 3Dimension Processor.
9. Video 1 Input (RCA)
Connect the Video 1 input to the Left Composite video output on the 3Dimension
Processor.
The Video 2 and Video 3 inputs are not used with the D-73d. Connect your
Composite video sources to the 3Dimension Processor.
D-73d Series Installation/Operation Manual
Do not connect any video source directly to this box.
Pr Pr
R R
Y Pb Pr H
G G B B R R
A B C D
8
2
TRIGGERS
1 2 3
T
F G
HDMI 1
Video
HD2
Pb Pb Pr Pr Video 3 Video 3
V
E
9
13
System Overview

Rear Panel Layout

3 4 5 6
Display Control
USB RS-232
IR
H
HDMI Out
HDMI 3
To Display
HDMI Out
Ethernet
Audio Only
10 11 12 13
RS232
PC / Control
14