Table of Contents
Advertisement
Sender Address: Input the sender's e-mail address, so that the receiver can recognize the sender
when an Event message is received.
Attach Image: Check this box if you want to attach an image when an alarm is triggered or an IP
camera detects events.
This server requires a secure connection (SSL): Check this box to enable the SSL function. Enable
this function means you can access the camera through the SSL protocol that provides
communication security over the Internet.
Send Test Email: Click the Test button to send a testing email to the assigned address.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous
settings.
【Set FTP Server】The settings relating to the FTP server used to transmit the alarm recordings can
be configured here. Note that to enable uploading recordings to the FTP server function, you have
to check the Upload to FTP item on the Event dialog box (see 7.7.1 Event Settings).
FTP Server: Enter the IP address or the host name of the FTP server.
FTP Port: Enter the port number for the FTP server. Default is 21.
Recording Path: Assign the recording path.
User Name: Set FTP User's name.
Password: Set FTP password.
PASV mode: Check to enable Passive mode. Passive mode is normally enabled. If a connection
cannot be established, uncheck "PASV Mode".
Test FTP Server: Click the Test button to send a testing file to the assigned FTP server.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous
settings.
37
EHN Series
Advertisement
Table of Contents
