Table of Contents
Advertisement
c.
Insert the network / PoE cable through the Cable Conduit, if your network / PoE cable
already has a RJ-45 connector, then you can use the Slitted Cable Conduit.
Slitted Cable Conduit
d.
Optionally insert the additional wires, such as power (if you want to power the camera
through a 12 VDC power source), alarm and audio cables, through the other Cable Conduit.
Note that one Cable Conduit can only be inserted with one cable. The Cable Conduit has
been tested to support cable diameter between 5.3mm and 6.4mm. Please refer to the
image below to bundle the lose wires before inserting to the Cable Conduit.
e.
Tighten the Screw Cap all the way to the Adjustment Ring(s).
f.
Due to the variable cable diameters, for better waterproofing, it is strongly recommended
that you apply silicon sealants to the inner Screw Cap.
7.
Connect the network / PoE cable to the LAN / PoE port on the camera module.
8.
If you have inserted additional wires, connect the wires to the terminal block. Please refer to 4.3
Terminal Block for pin assignment.
10
EHN Series
Advertisement
Table of Contents
