Table of Contents
Advertisement
IP address: When DHCP is not used, the user needs to manually enter the IP address of the camera.
Do not enter an IP address that is already used for your computer or other network cameras.
Subnet Mask: This field is used to set the subnet mask for your network, so that the IP camera will
be recognized within the network. Example: 255.255.255.0. When DHCP is selected, the DHCP
server will assign this value automatically.
Gateway: This field is used to set the gateway for your network so that the IP camera will be
recognized within the network. When DHCP is selected, the DHCP server will assign this value
automatically.
Primary DNS: Enter the IP address of the DNS server if this is provided by an ISP.
Secondary DNS: If your ISP provided you with a secondary DNS address, please enter it here.
Username: Enter the account's username (used only for PPPoE).
Password: Used only for PPPoE.
IPv6: Enter the IPv6 details in this area, if this applies to your system.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous
settings.
【Port Settings】Enter the HTTP, HTTPS and RTSP port numbers. Check the Enable UPnP Port
Forwarding box to enable the UPnP function. Click Apply to save the settings.
Promoted by the UPnP Forum (Universal Plug and Play), the UPnP is a networking architecture
providing compatibility among networked devices listed in the networked device table. Enable the
UPnP function means you can directly connect the cameras listed in the networked device table
by clicking on them.
Note:
1. For the UPnP function to work, an UPnP-enabled router is required.
2. The UPnP function may fail owing to the compatibility between the camera and the router.
【Multicast Settings】Enable if required, fill in the setting options and click Apply to save.
33
EHN Series
Advertisement
Table of Contents
