Configure The Snmp Trap Management - TRENDnet TPE-224WS User Manual

TRENDnet User's Guide
Modify SNMP Community Settings
If you need to modify a Community Table entry, you must first delete the entry by using
the procedure below and then re-enter it with the modification by creating a new
Community table entry.
Delete SNMP Community Settings
•
To delete a Community Name, click Delete next to the entry in the table that
you want to remove.
• The deleted Community Name is no longer displayed in the Community table.
No confirmation message is displayed.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2014 TRENDnet. All Rights Reserved.

Configure the SNMP Trap Management

SNMP > Trap Management
A Host IP address is used to specify a management device that needs to receive SNMP
traps sent by the switch. This IP address is associated with the SNMP Version and a valid
Community Name in the Host table of the switch.
1. Log into your switch management page (see
on page 7).
2. Click on SNMP and click on Trap Management.
3. Review the settings.
Create Trap Host Table Entry
Use the following procedure to create a trap Host table entry:
• Enable trap management by selecting the radio button next to Enabled at the
top of the page. By default, trap management is enabled.
• Enter the Host IP Address for the management device that is toreceive the
SNMP traps.
•
Enter the SNMP Version, either v1 or v2c, that is configured for the host
management device.
•
Enter a Community Name that you have defined previously in the SNMP
Community table. The Community Name must correlate with one of the
communities displayed on the SNMP Community Table page. If you enter a
Community Name that has not been pre-defined, the Trap Host entry is
displayed, but agent/manager communication fails.
•
Click Add. The new host is added to the table.
TPE-224WS
"Access your switch management page"
50